- Voltage: 12V
- Item Type: Atmosphere Lamp
- Brand Name: Heng Si Cheng
- Origin: Mainland China
- Item Type: Atmosphere Lamp
- Name: Heng Si Cheng
- Origin: Mainland China
- Color: White,ice blue,blue,red
- Length: 60cm,100cm,120cm,150cm,180cm,200cm,220cm,240cm
- Features0: Scan Lighting Car
- Features 1: Car Hood Light Strip
- Features 2: Car Daytime Running Light
- Features 3: Daytime Running Lamp
- Features 4: Waterproof
- Features 6: Auto Diy Cutter Lights
- Features 7: Highlight
- Features 8: Decorative Ambient Neon Lamp
- Features 9: Superbright
- Features 10: Upgrate Light
Item Type : Atmosphere Lamp
Brand Name : Heng Si Cheng
Origin : Mainland China
12V LED Daytime Running Light Scan Starting Car Hood Light Strip Waterproof Auto Engine Hood Guide Decorative Ambient Neo
Reminder:
1、When installing, be careful not to squeeze the car onto the tail of the light strip, otherwise the light beads will be crushed and damaged, causing the light strip to not light up.
2、The light strip does not support cutting. If the light strip is cut, it will cause asymmetric scanning on both sides when starting scanning.
Describe:
– Light source: LED
– Light colors: white/ice blue/blue/red
– Voltage: 12V
– Length: 60cm/100cm/120cm/150cm/180cm/200cm/220cm/240cm
Feature:
– Newly designed car decorative lights with start-up scanning function
– Side LED and corresponding hood design can provide you better lighting effect.
Installation tips:
– How to install the light strip
1. Apply double-sided tape to the two inner sides of the cover.
2. Fix the light bar on the double-sided tape.
3. Note: The cable position should be close to the windshield side, not close to the end of the central grille, otherwise it will affect the wiring and the normal opening of the hood.
– How to connect the wires?
1. The black wire is connected to the negative pole + the red wire is connected to the ACC = the engine starts to light up.
2. The black wire is connected to the negative pole + the red wire is connected to the DRL = turn on the DRL to light up.
3. The black wire is connected to the negative pole + the red wire is close to the light = the low beam is turned on.
4. The black wire is connected to the negative pole + the red wire is connected to the highlight light = the highlight light is turned on.
Notes:
1. Please allow 0.5-1 inch difference due to manual measurement. (1 inch = 2.54 cm).
2. Due to different computer screens, the actual color may be slightly different from the product picture, thank you for your understanding
3. It should be noted that during installation, please do not allow your car to squeeze the tail of the light strip. If squeezed onto the light strip, it may cause a group of light beads to break and lose their brightness.
4.The light strip does not support cutting. If the light strip is cut, it will cause asymmetric scanning on both sides when starting scanning.
Reviews